so i have a 1990 ninja 600 and i have recently begun to work on it however it has no spark anyone have any ideas?.
just need some help with ideas and ill try em
thanks
Ok you lost me on the it has fire but no spark ... lol Generally fire is spark. If it isn't getting any spark from the plug the start chasing components back. Start at the plugs and go all the way back to the battery if ya have to. Not sure which coils yer bike uses but if it is the same a a MK1 Bandit 600 then from what I hear they have a issue of going out.
No spark or a week spark?
Could be anything from the switch on down.
Never seen coils go and CDI's are usually pretty tough.
Check to see if yours has been tampered with.
Some guys will drill holes into them.
Or take them apart to mess with the Rev Limiter.
Water gets in there and they can Go.
Little Black Box usualy down under the seat.
Has a bunch of wires going into it.
Pull the wires and check for moisture and Rust on the terminals.
Also look for silicome or drill holes, this means it's been messed with.
ah knew i was forgetting something. i checked just about everything else with the ohm meter
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Custom Fighters - Custom Streetfighter Motorcycle Forum
1.6M posts
40.4K members
Since 2006
A forum community dedicated to Custom Streetfighter Motorcycle owners and enthusiasts. Come join the discussion about performance, modifications, builds, classifieds, troubleshooting, maintenance, and more!