Custom Fighters - Custom Streetfighter Motorcycle Forum - View Single Post - 2nd gen sv1000 - 2008 gsxr swingarm
View Single Post
Old Streetfighter Motorcycle Forum Post 10-01-2015, 05:54 AM   #12
TheMoose
Senior Member
Fighter
TheMoose's Avatar on CustomFighters.com Streetfighter Motorcycle Forum
Local Time: 12:00 PM
Location: Maine
Posts: 217
Flip Offs: 0
Flipped Off 2 Times in 2 Posts
TheMoose is a glorious beacon of lightTheMoose is a glorious beacon of lightTheMoose is a glorious beacon of lightTheMoose is a glorious beacon of lightTheMoose is a glorious beacon of lightTheMoose is a glorious beacon of lightTheMoose is a glorious beacon of lightTheMoose is a glorious beacon of lightTheMoose is a glorious beacon of lightTheMoose is a glorious beacon of lightTheMoose is a glorious beacon of light
Default Re: 2nd gen sv1000 - 2008 gsxr swingarm

Ok this is the part were I'm confused about what the common method of "filling in the blanks" when it comes to mounting and aligning the sprockets... I figure that to center the rc51 (180mm) in the sv1000 frame (235mm swingarm) I would use 27.5mm wide bushing/spacers but at that point is all that's left is a spacer to bring the rear sprocket to get inline with the front?
TheMoose is offline   Reply With Quote on our streetfighter motorcycle forum

Advertisement
These advertisements only appear for guests, register now for free to remove these ads!