Custom Fighters - Custom Streetfighter Motorcycle Forum banner

zx10r forks to zx6r stem problems

5K views 13 replies 5 participants last post by  Bluedrags 
#1 ·
so i have a 95 zx6r and im swapping some 07 zx10r forks on to it, i have everything ready to go the problem now is the stem. I cant just swap over my stem into the 10r stem since the bottom ID is 5mm different (10r is 35mm mine is 30mm) i do have a zx6r J stem which would be perfect since it shares the top ID of my zx6r bearing (25mm) and the bottom of ID of the 10r bearing. of course a spacer is required for the top if i do the J stem. But swapping the J stem is now a problem since its about an inch too long as seen below. Any ideas on what to do? get some one to thread the stem down more? im not too sure
 
See less See more
1
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top