Custom Fighters - Custom Streetfighter Motorcycle Forum banner

yans swingarm build

19K views 32 replies 1 participant last post by  yantosh 
#1 ·
gotta single sider to build fer a guy , been in the planning stage fer ages , mocked up a few bits , best get started eh ?

make from steel , a bit heavy but i'm more confident with steel welding for the moment

it'll hold a 280 tyre




we got a date, of course in my infinate wisdom i welded some bits before i took the pic

pivot point bits, all milled and bored



pivot tube



the 3 bits glued together





 
See less See more
6
#31 ·
hellow again , been up to my eyes in getting ready for the tt

got back to this today

started the final bracing , i'll finish these off , get it in the jig and weld it , after that that should be the arm part done

mocked up a temp spacer to hang a chain on too







 
#33 ·
wee update here , while the arm was finished months ago, the bike in question had stalled slightly , enough is enough tho

the arm is in , all spaced up , the rear hub is all finished , caliper mounted, sprocket on , temp chain on , front sprocket made , outrigger plate mate , slave cylinder mounted and i'll have the wheel back on as soon as i fit the torque arm







 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top