Custom Fighters - Custom Streetfighter Motorcycle Forum banner
1 - 7 of 7 Posts

·
Newbie
Joined
·
186 Posts
Discussion Starter · #1 · (Edited)
91-93 Honda VFR Single Sided Swingarm, GSXR SRAD parts

Hey all,

I have the following for sale. (Basically the bike you see in my avatar, project never took flight)

91-93 Honda VFR single sided swingarm(s) - (almost two complete swingers) for sale, including the wheel. I'd prefer to sell them all as one. - $500 OBO gets it all.
http://cleveland.craigslist.org/mpo/5014902297.html

98-99 Suzuki GSX-R 750 Power Commander USB III - never used, installed once to make sure the engine would run as it was all connected, but bike was never ran on the street (it was a project that never took flight). - $200 OBO
http://cleveland.craigslist.org/mpo/5015022535.html


98-99 Suzuki GSX-R 750 Engine Kit. This is everything for the engine to make it run. Engine, starter, wire harness, ecu, reg/rec, gauge, exhaust (it's aftermarket and will need a slip-on), radiator, airbox, throttle boddies, fuel pump, gas tank (it'll need work as last time I used it was over 5 years ago and there may be rust), and anything else that allows the engine to run properly. - $1200 (I believe for everthing, this is a smashing deal!!!)

98-99 Suzuki GSX-R 750 wire harness. This is a complete wire harness with ecu and reg/rec. I got it as I thought my other was bad. It wasn't so I have another one. $200 OBO

98-99 GSX-R 750 throttle boddies. These were never used. The cable pull on it is bent a bit, but looks to be easily fixable. I'll send you pics if you're interested - $100 OBO
http://cleveland.craigslist.org/mpo/5015041677.html

98-99 GSX-R 750 Frame. No title as I only got a bill of sale (since lost) when I got it 7 years ago and never titled it. Now, in OH, I can't as i'd need a bill of sale from outside of the state and even then, it's very difficult. Will be great as a track bike or stunt bike frame. It has a bit of rash on it as shown in the pic of the following link. If you want the VIN, I can send it to you. - $150 OBO
http://cleveland.craigslist.org/mpo/5015041677.html

06 GSX-R 1000 front end. Everything but the wheel and fender. - $400 OBO
http://cleveland.craigslist.org/mpo/5014890181.html

If you want more pics of anything, I can get them for you. Just tell me what you want, what you really, really want!

I'm not on here very often, so e-mail me at [email protected] if you're interested. Let me know you're from Custom Fighers and I'll go a bit lower than those from craigslist. I'll ship, but it'll be at your expense.
 

·
Newbie
Joined
·
186 Posts
Discussion Starter · #2 ·
bump... I've changed a few prices.
 
  • Like
Reactions: ROBBO

·
Premium Member
Joined
·
50,498 Posts

·
Newbie
Joined
·
186 Posts
Discussion Starter · #4 ·
whats tha wheel width please? also ball park ship to 03835 if ya got time to check that out mate.
PM is good;)

6" wheel width. I'll check shipping today for a rough estimate. Since it'll be in two or three boxes (to keep things from getting damaged) I'm hoping it's not too much. I'll PM you what I find out hopefully later this evening.
 
  • Like
Reactions: ROBBO

·
walkrndwtwood
Joined
·
941 Posts
Unless the wheel was split, and widened, its a 5.5". :))
 
  • Like
Reactions: ROBBO
1 - 7 of 7 Posts
Top