[Candyman]

Swingarm off an 05 ZZR600, great condition, comes with chain slide and chain gaurd. Does NOT include pivot or axle or pivot spacers.
All bearings sound.

$45 shipped.

Shock off same bike, good condition

$30 shipped.

 

[tblumer]

pic?

 

[Candyman]

Of one or both? I can post pics tomorrow morning.

 

[tblumer]

the swinger please. lol, "I put the grrrrrr in swinger, baby"

 

[Candyman]

Here ya go. It does not have the bushing or washer that go on the right and left side respectively. And I'm pretty sure I'm going to need to keep the chain guide (black thing shown in pic) for myself too. I can throw in the stock chain gaurd though. Its in mint condition. Let me know

 

[tblumer]

I'm interested, can you grab a width measurement at the pivot for me.

 

[Candyman]

Will do, get back to you after lunch

 

[Candyman]

Ok, snapped a few pics of the pivot area. The width is 9 1/4" at the pivot. I took a measurement with a ruler and the pivot looks to take about a 21mm bolt, now that was no micrometer reading, just the best I could give you from a ruler. Hope this helps (sorry for bad lighting)

 

[tblumer]

thanks, gotta go measure it up today

 

[tblumer]

I'll take it. Is paypal okay? PM me.

 

[endo]

That's a little big for the pocketbike tblumer...whatcha cookin' up?

 

[tblumer]

I'm pretty sure the 98-02 swingarm will swap into my 97. I'd like to run a 5.5 inch rim in the back with some fatter rubber. I already have a 98 shock to swap in.

 

[endo]

cool...I couldn't afford anything at this point, but this swingarm fits into my bike as well! A bunch of guys on the ZX6E forum had switched to 95-97 swingers for run a 170 instead of a 160. I was gonna go that route, and still might, but a 180 would be oh so cool lol.