Custom Fighters - Custom Streetfighter Motorcycle Forum banner

1 - 4 of 4 Posts

·
Powder Guy
Joined
·
919 Posts
I have never used it (I am a big 3M guy when it comes to fg). If you can get it without paying thru the nose let me know. I am always looking to go greener
 

·
Ridin Dirty
Joined
·
377 Posts
looks interesting in that it will not eat foam molds. However, there is little info on its strength, viscocity or heat deflection. I am all about heat deflection when it comes to resins. I have tried all kinds of resins from polyester, to vinylester to epoxy. Only high temp epoxy is what I use now. every thing else begins to lose its rigidity over 80 degrees farenheit.
 

·
Swamp Witch
Joined
·
6,239 Posts
Discussion Starter #4
Yeah, that's the big question for me: what's its durability?

That's why I posted this here to see what people thought. It seems to be marketed mainly towards the arts. I'd be willing to try it out on a small, non-critical piece like a rear hugger or something to see how it goes, though.
 
1 - 4 of 4 Posts
Top