[Bandit1052]

Last stage. Gloss. I do not feel like it anymore !!!!

Has to be enough !!!!

 

[yantosh]

nice job

 

[Bandit1052]

nice job

Many Thanks. But you don't have to have it every day!

 

[Bandit1052]

New tire. New flat valve. Rebalanced !!!

 

[Bandit1052]

Installed ready!

 

[Bandit1052]

Not much new, but after the polishing and the new tire from the rear wheel rim, the front wheel suffered the same fate

First have to order new brake lines.

 

[Bandit1052]

So chain set and new spark plugs are also there !!!!

New bearings and a new shaft seal are also installed!

I think the red chain goes well with the rest.

 

[Bandit1052]

Ohhhh completely forgot, I also milled the holder for the expansion tank once.

Finding a suitable place is always such a thing when you come across such a part later on !!!

 

[Bandit1052]

So the new brake lines are there!

The laying is a little different .........

.............. I chose the route through the king bolt.

 

[Bandit1052]

ohhh completely forgotten, of course in the back too!

Please not disregard the retaining screws. That is not the final solution yet !!! Thanks !!!

 

[yantosh]

you pre-empted my comment about the screws , thought it very unlike you to use them

 

[370steve]

So the new brake lines are there!



The laying is a little different .........

View attachment 149914

.............. I chose the route through the king bolt.

View attachment 149915

very close to how i did mine

 

[Bandit1052]

very close to how i did mine

I looked at you but didn't find it. That'll come later with you! Correct ?

 

[370steve]

I looked at you but didn't find it. That'll come later with you! Correct ?

this was done when i did the dry build

 

[Bandit1052]

Very nice, too !

 

[Bandit1052]

Ohhh and quick release. Unfortunately, I can't keep up with that !!!!!!!!!!!!!!!!!!!!!!!!!!!!

 

[Bandit1052]

Hello I haven't written for a long time, but a lot has happened.

@ yantosh:
I've already got myself another screw!
And YES, the brake caliper bracket STILL looks shit.

I just wanted to have said it before you noticed.

Screws are made of titanium and go well with the front ones.

 

[Bandit1052]

When I made the frame to coat, I forgot 2 parts.

The front bracket from the engine.

Bad luck ! I polished a 5mm stainless steel plate to a high gloss and milled the whole thing again. Faster than plastic coating and cheaper.

Also goes well with it, I mean.

The one on the left is less visible because there is the holder for the thermostat.

 

[Bandit1052]

Laying the oil lines took me 3 weeks. No place. Connections exchanged again and again.

Just one example: It looked good like this.

Also with a front spoiler

But I did the math without the exhaust manifold. SHIT !!!!!

 

[Bandit1052]

And so it went the whole time. No place- wrong connection.

for example

here: No place up³