[Bluedrags]

Hi all I've just purchased a 7 inch round light I'm trying to fit to my z1000 2012 model and I'm a bit stumped at the moment.
I have been thinking about brackets coming off the forks but was wondering if you get a lot of vibration through them being a single mount each side.
Has anyone fitted a similar light to any bike and if they could post what they done so I might get some ideas.

 

[sebwiers]

There's millions of 1970's bikes that mounted 7'' lights that way, without worry about vibration.

 

[MikeGyver]

That's how I mounted the dominator on my SV. Some electrical cable clamps and bent R6 suspension linkages. Check my sig

 

[Moto-Madness]

Get some rubber washers or cut some out of old tubes and put them between the headlight and brackets. You should be fine with out them though.