Custom Fighters - Custom Streetfighter Motorcycle Forum banner
1 - 4 of 4 Posts

fighter transplant in NC
14,319 Posts
Discussion Starter · #1 ·
I bought these some time ago for a build that is not happening. I have a move coming up so I am clearing out the garage.

there are six momentary switches. they require a 0.625" hole for mounting. they are 0.712" in diameter. they have two poles in the back with screw type terminals as seen below. I cannot remember the rating. I purchased them for the starter button and horn of some custom controls that did not materialize.

the clicky switches were purchased for the turn signals and high/low beams of the controls. there are three of these. the mounting holes and button diameter are the same. they have four crimp style poles on the back. I'm sure these would take some creative wiring to get right. I'm not sure what they are capable of being used for.

all are brand new, never had power to any of them. o-rings are included. I took one of each type out of the packaging for pics

$35+ actual shipping for the lot
I will mail these in a flat rate box for $5.80 within CONUS. international buyers will pay actual shipping

I can separate them, but would rather not

  • Like
Reactions: ROBBO
1 - 4 of 4 Posts