[GSAfighter]

I got a spare wheel in the mail yesterday, when I tried to mount it, I see that I need a spacer.

Material: Steel, stainless?
length: 11mm
ID: 20mm
OD: 40mm

It's on the rear axle, which is torqued to 100Nm, so I guess steel would be the best. Thanks in advance.

 

[shinyribs]

I can make this. Aluminum works fine in this application also,I've done it myself and seen bikes from the factory built with aluminum wheel spacers.

Aluminum would be $25 + shipping. Stainless would be an extra $10. It's more expensive and time consuming to cut. Just let me know.

 

[GSAfighter]

I can make this. Aluminum works fine in this application also,I've done it myself and seen bikes from the factory built with aluminum wheel spacers.

Aluminum would be $25 + shipping. Stainless would be an extra $10. It's more expensive and time consuming to cut. Just let me know.

shinyribs, this spacer will go in between the swingarm and the brake rotor bracket, and both materials look to be steel. Do you think it might be a problem wedging in an Al spacer?

 

[GSAfighter]

I just read up, I don't think the material will be a problem since the actual load is not on it. shinyribs, I'll PM you for paypal info.

 

[GSAfighter]

Got my spacer today. shinyribs is da man. Now to put everything together this weekend. Woohoo