Custom Fighters - Custom Streetfighter Motorcycle Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Hi I'm building a fireblade fighter and I've fitted a vfr singal sided swingingarm with a triumph hub my question
Is I can't get the caliper to fir the disc , the disc seems to short , is there a different disc I can fit does anyone know of
 

·
Registered
Joined
·
3 Posts
The VFR single sided swing arm has the disk mounted on the axle , so doesnt matter what rim you run (assuming the offset is correct and doesnt hit the disk. So a stock VFR disk is all you need.

 

·
Administrator
Joined
·
5,256 Posts
I know the triumph disc has a smaller dia than the VFR800 disc. (I assume you are actually using a VFR750 arm and hanger / caliper, and I am guessing it is the same for that)

Unfortunately a VFR disc will not fit the triumph axle, 88mm vs 78mm bolt spacing. But a Triumph caliper hanger should fit the VFR hub, and give you the right positioning on the disc.

You can check out my measurement thread to give you some ideas: http://www.customfighters.com/forums/showthread.php?t=65092
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #4 ·
I have the vfr caliper and mountings and I have the triumph the problem is that the triumph disc is to small
And the vfr doesn't fit the hub
Is there a different disc I can fit
 
1 - 5 of 5 Posts
Top