Custom Fighters - Custom Streetfighter Motorcycle Forum banner
1 - 7 of 7 Posts

· Chemical X
Joined
·
88 Posts
Discussion Starter · #1 ·
After helping my friend do a SSSA swap on his ninja frame, his rear wheel is not aligned. It sticks out of the right side (if behind bike) by enough to notice it if stood behind.

Reason for this is probably the way the swinger was milled only on 1 side as the chain side couldn't be milled safely.

Is there anyway to get the wheel aligned? Also will the mis alignment cause a MOT failure?

Should he be looking at a custom wheel? Not sure how much could be milled safely off the wheel. VFR swinger with a Bros hub and wheel.
 

· Chemical X
Joined
·
88 Posts
Discussion Starter · #7 ·
Theres 10 inches of snow around my area so cant drive down to friends bike. I can take pic of my wheel alignment its a whole bros swinger but not as much out of align like my friends. Mines being corrected with some milling.

Would mine help or do you need his? Mines out of alignment slightly but mines easily fixed, im yet to take it to the engineers so it's sat in shed awaiting the trim :p
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top