Custom Fighters - Custom Streetfighter Motorcycle Forum banner

1 - 5 of 5 Posts

·
Bitches love Fighters
Joined
·
5,325 Posts
Discussion Starter · #1 ·
i noticed a few wires in the harness that go to nowhere yesterday when i was cutting a new harness down. one wire is from the speedometer to the main white clip and ends there with a bare spot on the other side of the connector and there is one coming from the left hand control to the yellow connector with nothing on the other side of the connector. i looked on the diagram and it shows them ending at the connectors like that. but why? whats the purpose of having those wires if they do nothing?

i circled them on this part of the diagram. any ideas?

 

·
ZUK ATTaCK
Joined
·
2,957 Posts
Could be different country models? They might use more/different wiring for things?

Or the same harness for each size motor for that gen?

I don't know anything though lol just guesses.

Sent from Motorcycle.com Free App
 

·
Bitches love Fighters
Joined
·
5,325 Posts
Discussion Starter · #4 ·
It wasn't cut. It was like that from the factory. And it's even in the diagram. But this harness is only on the 07/08 Gsxr 1000 and is US non California specific lol. Not worried. Just curious


Sent from Motorcycle.com Free App
 

·
Bitches love Fighters
Joined
·
5,325 Posts
Discussion Starter · #5 ·
It looks like The Br/Y is for the immobilizer indicator light on such bikes. The W on the dimmer switch is for bikes where the low beam goes off when the high is turned on.


Sent from Motorcycle.com Free App
 
1 - 5 of 5 Posts
Top